Neff S51E50X1GB User Manual download pdf (Page 17)

en

17

Timer programming

Timer programming *

* depending on model

You can delay the start of the programme

by 3, 6 or 9 hours.

–Switch on ON/OFF switch (.

– Keep pressing the Preselected starting

time button 0 until the appropriate

display 3h, 6h or 9h is lit.

– Press START button h, timer

programming is activated.

– To delete the preselected starting time,

keep pressing the Preselected starting

time button 0 until none of the

displays 3h, 6h or 9h is lit.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when neither

of the two displays ` or X is lit.

The end of the programme is also

indicated by an acoustic signal.

The buzzer volume can be set in 4 stages.

Accordingly 0, 1, 2 or 3 displays are lit

(see water hardness table). Factory

setting: 2. This function can be changed

as follows:

– Open the door.

–Switchon ON/OFF switch(.

– Hold down button > P and press

START button h until the dry

display ` and salt refill indicator )*

flash.

– Release buttons.

– Keep pressing button > P until

the salt refill indicator )* and rinse

aid refill indicator )" flash.

– Release buttons.

The refill indicators )* and )" flash

and the displays # and + are lit

(= Setting 2). The set buzzer volume

can be heard.

To change the setting:

– Press the button < H until

the required setting has been selected.

– Press START button h.

Thedisplays go out. Theselected

setting is saved.

– Close the door.

Note

To save energy, the dishwasher

automatically switches off after the end

of the programme.

Interrupting the programme

– Open the door.

– Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave the

door ajar for several minutes and then

close. Otherwise, expansion (pressure)

may cause the appliance door to

spring open or water to run out of the

appliance.

– To continue the programme, switch on

the ON/OFF switch ( again.

– Close the door.

Terminating theprogramme

Terminating the programme

(Reset)

– Open the door.

– Press START button h for

approx. 3 sec. until all displays go out.

– Close the door.

The remaining programme sequence

for draining the residual water takes

approx. 1 minute.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments